Pin-straight hair is actually a hairstyle which is always wanted by most ladies. Getting one from the hair salon would normally cost you a considerable amount of money. However, if you know how to do it on your own in your house, no one will ever know the difference on how you obtained it. Read this article to find out ways to get pin-straight hair.
Thoroughly clean, dry and detangle hair
Remove dirt and excess oil from the hair by shampooing it well. After that, wash the shampoo thoroughly from hair by using cold water. Then, dry your hair by patting it with a towel. Then, have a big-toothed comb to comb your hair and remove the tangles. Start combing your hair at the tips, slowly untangling any knots of hair, and do it upwards. This way, not only will it be easier for you to do the untangling, but it\'ll also reduce hair damage.
Make use of heat protectant
Buy a heat protectant, such as organic argan oil, and use it onto your hair. Most heat protectants tend to make hair seem too oily; thus, you have to apply only a small amount of it. In case it comes in a spray bottle, 1 or 2 sprays will just do. If it\'s in a liquid form, put a little amount unto the palm of your hand and put it on to your hair starting from the tips and going upwards.
Utilize a hair dryer
Right after applying the heat protectant, buy your hair blow dryer and use it to dry your hair even more.
Separate your hair into sections
Separate your hair into portions, so that styling it\'ll be an easy task. Separate the top half of your hair like you\'re going to make a half-ponytail hair style. Then, secure it using a hair tie or clip. For the lower part of your sectioned hair, separate it into 2 to 3 parts, based on the depth of your hair.
Take out hair ties
Take one hair tie off from one hair portion of your hair. Nevertheless, choose a section that isn\'t too thick so that the heat supplied by the hair straightener can go through that entire area and really straighten it.
Make use of hair straightener
Switch the hair straightener on and enable it to warm up so that it\'ll be ready to use. After that, position it on the part of your hair that is next to the roots. Nonetheless, do not position it very close to your scalp because it may burn the skin. While still having the straightener, glide it down your hair. As you reach near the end, direct the gadget outwards. This would prevent the ends of the hair from going inwards, because your goal is to have pin-straight locks. However, you mustn\'t exaggerate this, or you might get curls rather than straight hair. Depending on your own hair\'s width, you might need to repeat this process on the identical portion of your hair a few more times.
Work on the remaining hair sections
Do the same process you did on the very first area of your hair to the other hair sections. If a section is very thick, split it into smaller portions, only when necessary.
Exposing your hair regularly in intensive heat would cause harm to hair. Thus, always use a good hair protectant, and let your hair relax from the heat at least a few times a week.
Article Source: http://www.articlesbase.com
